Titanlak wood effect 375ml
Special effect lacquer, made of polyurethane based on high solids technology. Easy to apply Covering. Smooth, hard, resistant and silky finish. Color, veined and natural wood look. Washable. Intermingling and weatherproof colors.
Interior and exterior. Special to imitate wood with a single layer. On any non-porous or enameled surface: doors, frames, cabinets, appliances, dumps, windows, etc.
Ureatained alkyd nature.
Color (UNE EN ISO 11664-4) Veined wood. Color range
Density (UNE EN ISO 2811-1) 1.10 - 1.16 Kg / l.
Yield (UNE 48282) 10 - 12 m2 / l.
Drying at 23 ° C 60% RH (UNE 48301) 6-8 hours.
Repainted at 23 ° C 60% RH (UNE 48283) 24 hours.
Application Methods Pallet (width 7 - 8 cm).
Cleaning Utensils Solvent Odorless or mineral spirits.
Flash point (UNE EN ISO 3679) 40 - 41 ºC.
Volume Solids (UNE EN ISO 3233-3) 50 - 52%.
VOC (UNE EN ISO 11890-2) 2004/42 / IIA (i) (600/500) Max. VOC 400 g / l.
Presentation 750 ml and 375 ml.
Variations in temperature, humidity, thickness, dyeing or depending on the type of support, etc., can cause changes in drying, yield or other properties.
How to use
Stir well in the container. The surfaces to be painted should be clean, dry and primed properly. Remove any dirt, grease, badly adhered rust and coatings using solvent or stripper, as needed.
If possible, disassemble objects that may hinder the trajectory of the pallet (locks, knobs, peepholes) Apply in
abundant and uniform undiluted layer, ending with long strokes in the direction of the grain. Immediately and up to a maximum of about ten minutes after application, highlight the veins as desired, gently running the tip of the drained pallet and in continuous, parallel or wavy strokes and in the same direction. With more uneven tip paletinas, more intense veins will be obtained. Make the joints by zones and parallel to the veins.
SURFACES NOT PREPARED:
Wood: Sand the wood in the direction of the grain, clean thoroughly, remove resin or resin secretions and kill live edges. Apply TITAN Protector, TITAN Sealer or Multipurpose Preparation according to needs.
Iron: Titanlux Synthetic Minio or Multipurpose Preparation. For outdoor work, two coats of the selected primer will be necessary. Indoors, one layer will be enough.
Melamine laminates: degreasing and sanding until tinting.
Other supports: Consult.
In all cases to:
Interiors: 1 single layer of Titanlak Wood Effect is, in most cases, sufficient.
Exterior: for greater weather resistance, apply 2 coats of Titanlak Wood Effect.
MAINTENANCE SURFACES ALREADY PAINTED IN GOOD CONDITION:
Wash, sand gently and apply Titanlak Wood Effect directly.
MAINTENANCE SURFACES ALREADY PAINTED IN BAD CONDITION:
Remove completely and proceed as on unprepared surfaces.
Before using the product, read the package instructions carefully. For more information consult Safety Data Sheet.
Store tightly closed containers sheltered from sources of heat and temperature below zero. Storage: 36 months in original unopened container.
Follow local legal regulations. Help protect the environment, do not dispose of waste in the drain, deposit it in
The nearest recycling center.
Calculate the amount of product you will need and thus avoid waste and extra cost.
Store excess product well stored for new use.